R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Leichtmetall
Showing results 1 to 25 of 82
Search took 0.01 seconds.
Forum: Nitro On-Road
05-14-2016, 04:54 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

I think it does not go. But you can use every...

I think it does not go. But you can use every Module 1 Cluth with the original Edam Gearbox. I use Serpent Centax2 Pinions on original Edam Clutchbell. Long Time ago, i used a MRX4 Clutch complete...
Forum: Nitro On-Road
02-13-2016, 06:08 PM
Replies: 21
Views: 8,657
Posted By Leichtmetall

did you have a look to homepage of this...

did you have a look to homepage of this manufacturer?
http://www.smp-slide.ch/
The car was made in Switzerland, some years ago. That time, it was a good car.
LM
Forum: Nitro On-Road
02-10-2016, 02:39 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

i changed the Ballbearings of one-way-axle...

i changed the Ballbearings of one-way-axle against the excentric rings from the rear hubs with 18x12x4 bearings. cut away the nose on outside it gave me the chance, to change the onewayaxle a little...
Forum: Nitro On-Road
07-07-2014, 03:29 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

When i had this Problem sometimes with an older...

When i had this Problem sometimes with an older Frontbumper, i made following:
I take three tires on table, puting car on it. one tyre under the rearend of chasis, and even one under the left and...
Forum: Nitro On-Road
07-06-2014, 09:06 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Problem with Brake? touching the bulkhead? Are...

Problem with Brake? touching the bulkhead?
Are you sure, that you mount the brakepads correct? The Ends of the brakepads are different. be sure, that you mount the correct direction :D
LM
Forum: Nitro On-Road
07-05-2014, 12:55 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

I ask, because i changed to the one-piece-disk....

I ask, because i changed to the one-piece-disk. With original, i had no Problems during a Race, but after each Race, i hat fo file off the little "curbs" around the pin-holes. if i forgot it, ich had...
Forum: Nitro On-Road
07-04-2014, 04:38 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

A question about the Brake: Which Brakedisc you...

A question about the Brake:
Which Brakedisc you are using? The original 3-Part Brake-Disc or the on-piece-brake-disc (Option-Part) Or is anyone using another Disc? And, how are your Experience?...
Forum: Nitro On-Road
06-28-2014, 04:04 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Is here still any Action? Edam-Drivers still in...

Is here still any Action?
Edam-Drivers still in Racing?
Leichtmetall
Forum: Nitro On-Road
02-08-2014, 12:08 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

bringing in the two new holes in stock-saver, the...

bringing in the two new holes in stock-saver, the steering rods are a little clother together. I took sand-paper an made the outside a little smaler, then it works. Until now, no one of the Rodends...
Forum: Nitro On-Road
01-03-2014, 02:18 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

i had this slide-type-servosaver in my Razor II....

i had this slide-type-servosaver in my Razor II. It gave more steering, but the cauge of steering track rod will also change. and then i had a disharmonic car, sometimes oversteer, sometimes...
Forum: Nitro On-Road
12-23-2013, 03:03 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Itīs poor, but i think there will be no upgrades...

Itīs poor, but i think there will be no upgrades for RazorII. There was a prototype some years ago, but nothing was coming from.
About the rear Hubs. In Razor II or the upgrade-Kit for OS2 Rims, the...
Forum: Nitro On-Road
08-09-2013, 01:40 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

:confused::confused::confused: sorry, when i...

:confused::confused::confused:
sorry, when i open my Site, there is nothing happen. Please, can you tell me, what your antivirus found?
Iīm not the Programmer, sure, itīs my Site, but Script is...
Forum: Nitro On-Road
08-08-2013, 12:44 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Understand i right? You have a complete other...

Understand i right?
You have a complete other performance from Razor1 to Razor2?
The difference is not only the Chasisplate. The rear End, i mean upper arms and Knuckles is different. So the...
Forum: Nitro On-Road
08-07-2013, 01:31 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

sorry for question, du you seek an...

sorry for question, du you seek an overdrive-calculator?
you can find one on my website:
www.Edam-Racing.de
please register first (no panik, no personal Datas needed) and then you can download in...
Forum: Nitro On-Road
08-03-2013, 01:34 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Today i had my first testing Runs with the...

Today i had my first testing Runs with the one-piece-brake-disc. And i have to say, the money was a good investment :D No stuckering Brake, every round the same Brake-Power and i have no doubt about,...
Forum: Nitro On-Road
07-02-2013, 11:09 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

The Aluminium Pivots are included in Razor 2 Kits...

The Aluminium Pivots are included in Razor 2 Kits since some Month.
Here in Germany, the Razor has to much weight. We should have more than 2400 Gramms, but my Razor with Body has with empty...
Forum: Nitro On-Road
07-02-2013, 11:04 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

The Screws with the rolls in the middle of Shoe i...

The Screws with the rolls in the middle of Shoe i turn in, until the clutch-shoe is just lifting. then i stop turning in.
And the Screws with springs, starting-setup is the head in one line with...
Forum: Nitro On-Road
06-21-2013, 03:48 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

my damage was a little bigger :cry: both lower...

my damage was a little bigger :cry:
both lower arms broken. both knuckles with hairline-crack. left upper arm puled out from knuckle and destroyed. left damper-rod not longer inline. and chasis is a...
Forum: Nitro On-Road
06-20-2013, 09:14 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Sometime ago, i told about the new kits with the...

Sometime ago, i told about the new kits with the lightweight Pivots.
One of them was broken at my car during a little jump.
at last Race, i had a really heavy impact. My car was in the rear...
Forum: Nitro On-Road
02-28-2013, 06:50 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

Was there any Razor-Dirver at Winternats in...

Was there any Razor-Dirver at Winternats in Florida?
LM
Forum: Nitro On-Road
10-08-2012, 02:41 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

One thing i knwo since last weekend: The new...

One thing i knwo since last weekend:
The new Pivots have less weight, wil give the car more performance. BUT, the break realy fast if you have a little impact. The dont forgive Driver-Errors so easy...
Forum: Nitro On-Road
10-03-2012, 04:40 PM
Replies: 303
Views: 94,322
Posted By Leichtmetall

For all Razor-Owner with an older Razor, i have...

For all Razor-Owner with an older Razor, i have two Pics which should be from great interest
Edam told none about it, but the one pivots are from Kit of 2011, the others are from a Kit of 2012...;)...
Forum: Offroad Nitro Engine Forum
09-10-2012, 03:29 PM
Replies: 15
Views: 10,722
Posted By Leichtmetall

Have a Look on Axe Website: ...

Have a Look on Axe Website:
http://www.axemotor.it/Axemotor/Break_in.html
It seems, that all Axe-Engines have same starting point of carburetor...
Leichti
Forum: Nitro On-Road
08-08-2012, 11:42 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

When shorting wheelbase, you slide the lower arms...

When shorting wheelbase, you slide the lower arms in front? How do you handle the space between lower arm and anti-roll-bar-holder?
And, for a little more flex:
Let only the two front screws from...
Forum: Nitro On-Road
08-06-2012, 11:07 AM
Replies: 303
Views: 94,322
Posted By Leichtmetall

What springs you use? The front looks like old...

What springs you use? The front looks like old blue Serpent? The original Green in the rear?
At my last Homerace, i had to use my Rain-Razor (1). And i had to drive with Rain-setup on dry track. And...
Showing results 1 to 25 of 82
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.