R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: electricRCrocks
Showing results 1 to 25 of 132
Search took 0.01 seconds.
Forum: Electric Off-Road
08-15-2014, 08:23 PM
Replies: 0
Views: 434
Posted By electricRCrocks

Videos and Photos 2014 East Coast Champs RCE

RC Excitement in Fitchburg, MA hosted the 2014 East Coast Champs a couple weeks ago. Adam and Rhonda Drake attended along with some other great drivers both regional and national. I have posted 1080p...
Forum: Electric Off-Road
06-25-2014, 12:38 PM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

I second Lowe on the grease/lube on the pucks...

I second Lowe on the grease/lube on the pucks especially for front center. Also, you can "rotate" them to get wear on both sides which should help you get some longer life.
Forum: Electric Off-Road
01-14-2014, 05:45 AM
Replies: 9
Views: 941
Posted By electricRCrocks

I agree on the Junsi iChargers. I have a 306B...

I agree on the Junsi iChargers. I have a 306B which can charge up to 30A or up to 6 cells. Always check the C rating on the LiPos to see what charge rate they can handle, and highly recommend balance...
Forum: Electric Off-Road
12-17-2013, 05:37 AM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

MIP 2.0 Indoor Clay/Loam Setup for RCE in Fitchburg, MA

For those of you running indoor hard packed clay/loam, see the link below for a great starting setup for the MIP converted SCTE 2.0 with MIP #7 pistons. It is very consistent from one track to...
Forum: R/C Items: Wanted to Buy
11-20-2013, 04:59 AM
Replies: 7
Views: 323
Posted By electricRCrocks

YGPM

YGPM
Forum: Electric Off-Road
11-20-2013, 04:50 AM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

I am running one in my MIP SCTE and love it. The...

I am running one in my MIP SCTE and love it. The low end torque is especially helpful on smaller indoor tracks where I can make jumps easily from a short distance.

Key thing to note is the 4300kV...
Forum: Electric Off-Road
11-12-2013, 05:17 AM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

I am not sure what temperature you run in but I...

I am not sure what temperature you run in but I use 25wt oil with the MIP #7 Pistons and Brown valves and works great. Blue spring in the front and TLR Orange in the rear. Make sure ride height is...
Forum: Electric Off-Road
08-19-2013, 08:33 PM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

You are correct. #4 pistons were in the original...

You are correct. #4 pistons were in the original kit. The #7 pistons are the newest and allow for lighter weight shock oil. I have used the #7 pistons with great success. I like them much better than...
Forum: Electric Off-Road
07-31-2013, 01:03 PM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

Lightbulb :tire: I highly recommend getting camber and...

:tire:

I highly recommend getting camber and ride height gauges as it makes a big difference if those are really far off where they need to be. A little off isn't bad, but I have seen some...
Forum: Electric Off-Road
07-30-2013, 04:29 PM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

That's perfect. The reason I asked is I know that...

That's perfect. The reason I asked is I know that blue/black groove can make you traction roll but that track should work well with the setup I have currently. Only use the setup below if you have...
Forum: Electric Off-Road
07-30-2013, 05:08 AM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

I agree with Johnny. I highly recommend using the...

I agree with Johnny. I highly recommend using the MIP shock towers and the Bypass system as that is what all of my setups and many others here are based on and will be hard at times to give setup...
Forum: Electric Off-Road
07-26-2013, 06:47 PM
Replies: 9,438
Views: 1,575,972
Posted By electricRCrocks

Why do you use the inside hole instead of the...

Why do you use the inside hole instead of the outside hole?
Forum: Electric Off-Road
07-26-2013, 04:02 AM
Replies: 34
Views: 2,403
Posted By electricRCrocks

I always think it is a good idea to consider how...

I always think it is a good idea to consider how many people in your area run each vehicle. I've noticed certain areas tend to lean towards specific vehicles. It may help some in terms of setups too...
Forum: Electric Off-Road
07-24-2013, 04:40 AM
Replies: 762
Views: 206,651
Posted By electricRCrocks

That's good to know. I will try 16/39 without the...

That's good to know. I will try 16/39 without the fan first to see the temp difference to make sure it can run without the fan but will probably get one to keep the motor temp down in general.
Forum: Electric Off-Road
07-23-2013, 02:51 PM
Replies: 762
Views: 206,651
Posted By electricRCrocks

I am running the MIP Pro4mance conversion for the...

I am running the MIP Pro4mance conversion for the TLR TEN-SCTE 2.0. I was running 15/39 last weekend and had 177F on center of the can of the motor with outdoor air temp around 85F. That track I just...
Forum: Electric Off-Road
07-23-2013, 06:18 AM
Replies: 762
Views: 206,651
Posted By electricRCrocks

I have the Tekin 4300kV PRO4 HD motor and love...

I have the Tekin 4300kV PRO4 HD motor and love it. I know I can gear up more if I had a good heat sink and/or fan to run now that we are outside in the hot weather.

The Castle Creations blower fan...
Forum: Electric Off-Road
07-11-2013, 05:33 PM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

It depends on where you are running, but I will...

It depends on where you are running, but I will be starting with 50wt AE oil for outdoor and seeing how that works. Some of Matt's latest setups use 50wt with the stock setup saying 45wt so figure...
Forum: Electric Off-Road
07-10-2013, 12:57 PM
Replies: 8,898
Views: 966,205
Posted By electricRCrocks

If you have the new Tekin RX8 Gen2 it has a 7A...

If you have the new Tekin RX8 Gen2 it has a 7A BEC instead of the 5A before so should be able to do without the glitch buster.
Forum: Electric Off-Road
06-22-2013, 05:38 AM
Replies: 762
Views: 206,651
Posted By electricRCrocks

@Hoese37 I am preferential to large outdoor...

@Hoese37

I am preferential to large outdoor tracks so works great for me. However, the 4300kV HD can still do very well inside for those who can control it. I see the fast pro drivers running...
Forum: Electric Off-Road
06-20-2013, 05:29 PM
Replies: 762
Views: 206,651
Posted By electricRCrocks

Make your life easy and go with the HD 4300 and...

Make your life easy and go with the HD 4300 and don't look back. There is a reason why it is the latest and greatest motor. I can't wait to use mine in the new build.
Forum: Electric Off-Road
05-24-2013, 05:48 AM
Replies: 3,167
Views: 549,406
Posted By electricRCrocks

Received my Thorp tools and new Pro4mance...

Received my Thorp tools and new Pro4mance conversion kit for my new build for the summer. Thank you for the support, MIP.
Forum: R/C Items: For Sale/Trade
04-22-2013, 06:50 PM
Replies: 2
Views: 590
Posted By electricRCrocks

What are you asking for price and how much use?

What are you asking for price and how much use?
Forum: R/C Items: Wanted to Buy
04-06-2013, 04:00 PM
Replies: 2
Views: 252
Posted By electricRCrocks

PM Sent.

PM Sent.
Forum: Electric Off-Road
04-04-2013, 02:14 PM
Replies: 762
Views: 206,651
Posted By electricRCrocks

I'm looking forward to the Pro4 HD outdoors for...

I'm looking forward to the Pro4 HD outdoors for this summer!
Forum: Radio and Electronics
04-02-2013, 05:15 AM
Replies: 27
Views: 2,318
Posted By electricRCrocks

I have the Junsi iCharger 306b which charges up...

I have the Junsi iCharger 306b which charges up to 30A single port up to 6S. It has been my best purchase in RC! At 24V input it's a 1000W charger and at 12V input it's a 500W charger. I use the...
Showing results 1 to 25 of 132
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.