R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 3
1
2
3
Search: Posts Made By: donwhit
Showing results 1 to 25 of 63
Search took 0.01 seconds.
Forum: Electric On-Road
04-28-2013, 02:50 PM
Replies: 5,637
Views: 1,049,115
Posted By donwhit

Pinions

I have this problem with a TP 17.5 in a T4 in the UK.

On a T3/12 I ran pinions in the 37-40 range with a 72 spur - 48DP.
To get this gearing on a T4 I had to fit a 66 spur then a 37 pinion so...
Forum: Electric On-Road
01-07-2013, 02:55 PM
Replies: 670
Views: 172,156
Posted By donwhit

Hi, they are: M2.5 X 10 SOCKET COUNTERSUNK...

Hi,
they are:
M2.5 X 10 SOCKET COUNTERSUNK STAINLESS 20 PACK FREEPOST

from either ebay or:

http://www.triard.co.uk/
Forum: Electric On-Road
12-21-2012, 04:28 PM
Replies: 4,239
Views: 699,113
Posted By donwhit

T3 chassis

Lonestar - try the Smokem T3MX chassis. We think, after a few weeks running it on carpet, that its a real improvement on a standard T3/12 chassis.
Forum: Electric On-Road
04-06-2012, 02:35 PM
Replies: 4,239
Views: 699,113
Posted By donwhit

Xray gear diff

I agree that the O-ring is not needed.
What you should do is coat the mating faces of the diff cases with a thin smear of thick grease, add the gasket and screw up as normal.
I've built three this...
Forum: Electric On-Road
03-12-2012, 05:10 AM
Replies: 4,239
Views: 699,113
Posted By donwhit

Hi Skiddins, Ian has only tried the 1.6...

Hi Skiddins,

Ian has only tried the 1.6 topdeck indoors on carpet but it definitely gave more steering.
Forum: Electric On-Road
03-01-2012, 03:07 PM
Replies: 670
Views: 172,156
Posted By donwhit

Hi Skiddins, Tried one pinion lower (16) at...

Hi Skiddins,

Tried one pinion lower (16) at Stafford tonight. Ian said it was better on the short straights. Also tried a 15, gutless. Also tried an 18, seemed overgeared on same speedo settings....
Forum: Electric On-Road
02-27-2012, 02:52 PM
Replies: 670
Views: 172,156
Posted By donwhit

Hi Skiddins, short answer is: i don't know,...

Hi Skiddins,

short answer is: i don't know, I copied Ians settings off his laptop. Maybe someone else can provide this Tekin info.

Yes it is very low, but remember this was an indoor...
Forum: Electric On-Road
02-26-2012, 02:46 PM
Replies: 670
Views: 172,156
Posted By donwhit

13.5 motor timing

Hi Skiddins,

motor timing was 35deg, motor came off at 50deg.

Speedo is a Tekin RS Pro, firmware is 212.

Sensored
Timing advance 40
Timing boost 49
Turbo boost 13
Forum: Electric On-Road
02-26-2012, 08:56 AM
Replies: 670
Views: 172,156
Posted By donwhit

Ian Whittingham XRAY T3 2012 TQ and overall win using Z3R-S 13.5

Ian Whittingham drove his XRAY T3 2012 to TQ and overall win at the fourth round of Carpet Masters held at Stafford(UK) indoor track.

This was the first event using the 13.5 Z3R-S.

It was...
Forum: Electric On-Road
12-31-2011, 04:25 AM
Replies: 4,239
Views: 699,113
Posted By donwhit

Xray driveshaft replacement

If you really are unhappy with the absence of a retaining ring for the crosspin in Xrays driveshafts use the Atomic ones. We have been using these for indoor racing for about a year.
...
Forum: Radio and Electronics
12-23-2011, 11:28 AM
Replies: 12,554
Views: 1,875,640
Posted By donwhit

Where have all the Hobbywing download sites gone?

Hi,
I recently have been running my Extreme Stock ESC in blinky mode.

I want to start running in advancing mode and have spent some time today trying to find the download link for it.
I've tried...
Forum: Electric On-Road
06-26-2011, 02:37 PM
Replies: 4,188
Views: 698,982
Posted By donwhit

17.5 Stock Gearing

I run 17.5 zero timing. T311 with Novak Ballistic motor. I am geared at 70/38 which is 3.5 at 48DP. Motor temp around 103F with air temp at 29c. I use a motor fan.
Have a look at ...
Forum: Electric On-Road
04-24-2011, 04:26 AM
Replies: 23,359
Views: 2,659,651
Posted By donwhit

Gold star to the man who mentioned trim!:) Had...

Gold star to the man who mentioned trim!:)
Had to click the trim towards throttle high nearly all the way but it did set and appears to get full throttle and brake OK.
Interestingly, tried to move...
Forum: Electric On-Road
04-23-2011, 02:10 PM
Replies: 23,359
Views: 2,659,651
Posted By donwhit

Neutral width is set to 10, is this too tight? ...

Neutral width is set to 10, is this too tight?
Someone said to set around 7?
regards
Don
Forum: Electric On-Road
04-23-2011, 03:24 AM
Replies: 23,359
Views: 2,659,651
Posted By donwhit

Mutley thanks. Yes I tried reversing it. Still...

Mutley thanks.
Yes I tried reversing it. Still no go.
I should also have mentioned that I suspected the speedo as all my other kit works OK with other speedos. I was given another brand new RS,...
Forum: Electric On-Road
04-22-2011, 03:08 PM
Replies: 23,359
Views: 2,659,651
Posted By donwhit

Can't find neutral

Apologies if this has been asked before...
I have a Sanwa Super Exzes transmitter fitted with a Spektrum 2.4 module. The receiver is Spektrum. This setup has worked with Novak, LRP, Hobbywing etc...
Forum: Electric On-Road
08-10-2010, 03:35 PM
Replies: 3,480
Views: 545,868
Posted By donwhit

Routing wires

I route the wires over the belt but I made a Lexan right angle (bodyshell offcut) about two inches long and superglued it to the top deck.
regards
Don
Forum: Electric On-Road
08-01-2010, 02:26 PM
Replies: 5
Views: 1,020
Posted By donwhit

Underbodies

Try

http://slipstreamrcshop.co.uk/electric/products.php?cat=2

in the UK.
They haven't done one for the T3 but a 09 underbody can be made to fit on a standard chassis T3.
regards
Don
Forum: Electric On-Road
07-08-2010, 03:25 PM
Replies: 890
Views: 194,338
Posted By donwhit

SPEC.r in UK

Luke,
try

demonpowerproducts.co.uk
Forum: Electric On-Road
05-03-2010, 03:40 PM
Replies: 2,947
Views: 425,555
Posted By donwhit

not going at start

I agree this is apparently a problem.
We have a Xray T3,GM90 2010 with 11.6 software. NO other changes to settings.
The receiver is a Spektrum 2.4 (the very small one with the transparent case)...
Forum: Electric On-Road
03-18-2010, 04:18 PM
Replies: 3,480
Views: 545,868
Posted By donwhit

Quick roll cente holder plastic link

Does any one know if they have a T3 that does NOT have the moulded dot on the plastic link that is attached to the quick roll centre holder? See manual page 17.
We looked at four T3s tonight and two...
Forum: Electric On-Road
02-20-2010, 02:43 PM
Replies: 3,480
Views: 545,868
Posted By donwhit

Atomic driveshafts

I got mine from EGR Mart:
http://www.egrracing.com/shop/

good service
Forum: Electric On-Road
02-20-2010, 04:05 AM
Replies: 3
Views: 1,192
Posted By donwhit

Xray 009 diffs

Please read the manual or download it from the Xray site if you don't have one. Xray make big deal of how you run in the diff. Take from me, if you don't follow the process your diff will never be...
Forum: Electric On-Road
01-21-2010, 02:49 PM
Replies: 3,480
Views: 545,868
Posted By donwhit

Alloy shocks piston size

Flatout

The size you use must depend to some extent on setup, track, tyres etc.

Paul L uses 700 oil and 1.1 pistons on his Novak race winning modified setup.

My Ian runs 10.5 at Stafford and...
Forum: Electric On-Road
01-16-2010, 04:44 AM
Replies: 2,761
Views: 427,337
Posted By donwhit

Xray Alum shocks

Hi Paul,

saw your reply on using aluminium shocks on a T3.

You say you use 700 front but with which pistons?
The alu shocks come with a choice of 1.1,1.2 or 1.3 pistons.
We are currently...
Showing results 1 to 25 of 63
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.