MrUnlimited

Can imagine you sell it: too slow

karolpenconek

iTrader: (1)

Hello. I have also some rc boats. Boats are cool

My 32 inch catamaran powered by Medusa 36.80 1100kV on 8S li-po. It take in brust about 80A, it's 2400W for 2800g. (~6lbs) model 5.9 sec. for 130m. stand start

youtube.com/watch?v=GJY40BBeLNI

Also I have some mini eco's expert and standard, my own construction.

Regards Karol, Poland.

texazbadboy

iTrader: (7)

Here's a few pic's of my Vegas.Its got a GO.18,traxxas 2075 servo's,3/16 flex shaft,OEM hardware.Just waiting to get a prop to take it for a spin..

Hippie459MN

I really need to get my one boat up and going again. Been sitting for a few years now. I also need to get a new boat or 2 as well.

Seeing all of these amazing boats is giving me the itch again.

Preston777

iTrader: (9)

My rig that hasnt been ran it years, It's a DPI 7.5 tunnel with a never been cranked K&B 7.5 pro on it.

MrUnlimited

Good looking tunnel you have there. If the engine has not run for a while spray some WD40 in, remove the glowplug and turn the engine by hand. Fire it up using a low nitro fuel and let it run for a minute without touching the throttle. After that slowly run the boat in the water.

julianconde

iTrader: (3)

here is my tunnel boat the ODMBA 2009 Champion this boat has a andy brown modiffied engine,lawless lower unit,X438 Octura prop. 55 MPH little 29inch boat.

the second picture is my Ossi Modelbeau gas tunnel hull got second place at the Charleston Fall Nationals

racer35

Nice pics!!

racer35

Very nice!!

racer35

WOW!!! Nice fleet!

laedco58

iTrader: (4)

I'll try and post some pics of my armada. Wood Racing .21 Blackbird on the Left, CMDI Eagle SG .45 on the Right.

laedco58

iTrader: (4)

They look better when they are wet. I have higher quality photos of both on the water but the site won't upload them because the resolution is to high.70+ mph boats are fun to test, and an absolute adrenelin rush to race.

laedco58

iTrader: (4)

Here are a few more.

tcmodels

any one knows this speed control ? Price is very good

MrUnlimited

I would go for ETTI esc since the boards are packed in an epoxy layer so they are waterproof. I have one and love it. Here are they available: http://www.offshoreelectrics.com/pro...c-race-150-BEC