R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)
-   -   Maclan MMAX Pro not calibrating (https://www.rctech.net/forum/radio-electronics/997919-maclan-mmax-pro-not-calibrating.html)

stuffandthat 09-14-2017 10:07 PM
Maclan MMAX Pro not calibrating
 
Hi guys, I received the MMAX Pro ESC and 17.5t motor combo today. I had my LHS solder it up but I can't get the motor to work. When I go to calibrate it I get to the full throttle stage and the LED goes solid blue and then beeps 3 times. The calibration video and the instructions in the manual doesn't say anything about the 3 beeps.

I've reset my transmitter and set that up again, and I updated the firmware on the ESC and that still didn't help. Has anyone got any ideas or had this problem?

EbbTide 09-14-2017 10:56 PM
Originally Posted by stuffandthat (Post 15029909)
Hi guys, I received the MMAX Pro ESC and 17.5t motor combo today. I had my LHS solder it up but I can't get the motor to work. When I go to calibrate it I get to the full throttle stage and the LED goes solid blue and then beeps 3 times. The calibration video and the instructions in the manual doesn't say anything about the 3 beeps.

I've reset my transmitter and set that up again, and I updated the firmware on the ESC and that still didn't help. Has anyone got any ideas or had this problem?
The only time I've had a failed calibration is if the sensor cable is either loose, faulty or not installed. I'd check that first with a new one. Also maybe try the receiver binding process again before doing calibration.

stuffandthat 09-15-2017 02:13 AM
It was the sensor cable! Just needed to be pushed in to the ESC a little more. Thanks for your help!


All times are GMT -7. It is currently 09:31 PM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.