R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)
-   -   Hirosaka DC-1 servo died (https://www.rctech.net/forum/radio-electronics/860328-hirosaka-dc-1-servo-died.html)

xrayracer1 02-01-2015 02:21 AM

Hirosaka DC-1 servo died
 
I have a Hirosaka DC-1 low profie servo i bought for my Xray X1. It was brand new (As well as the car kit) and the servo only lasted about a dozen practice laps before it just died. I tried turning the switch on and off, i made sure that the plug was in the receiver properly......and nothing.:weird:

What would have caused this? Has this happened to anyone elese with this particular servo?

xrayracer1 02-09-2015 02:43 PM

Bump

freakshow__ 02-09-2015 03:52 PM

well....this did't exactly happen to me, but...

I had the same servo in my brand new Xray XB4 and it lasted about 30 minutes if that. A piece of the plastic top portion (closest to spline) snapped in a critical point where one of the gears rotated on. This caused that particular gear to destroy the other ones it meshed with. needless to say...I had no steering all of a sudden and that was why. Not impressed. I bought a Spektrum s6040 and haven't had ANY issues. Too bad....I thought being the name "Hirosaka" it would be good stuff...I think it's all cheap stuff re-branded with his name on it. The motors are made by speed passion.

xrayracer1 02-10-2015 12:44 PM

Yeah i thought with the name Hirosaka it would be good. I have a cheap feetech servo replacing it at the moment and its holding up better.....


All times are GMT -7. It is currently 07:31 PM.

Powered By: vBulletin v3.9.3.8
Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.