iCharger 406 DUO Charger
#606
Tech Initiate
Did you take off the protective film that comes on the screen when new?
Last edited by RLPowerSupplies; 02-16-2017 at 07:35 AM.
#609
#610
Tech Legend
iTrader: (51)
Join Date: Sep 2001
Location: Castle Mamba Max Pro. Feel its power!!!!!!!!!!
Posts: 21,220
Trader Rating: 51 (100%+)
#611
Tech Legend
iTrader: (51)
Join Date: Sep 2001
Location: Castle Mamba Max Pro. Feel its power!!!!!!!!!!
Posts: 21,220
Trader Rating: 51 (100%+)
I have a new 406 and it comes with the presetup different types of charge modes. So once I'm in charge mode and save the changes I made how do I setup up like a 2nd, 3rd or 4th profile say in the Lipo Mode. I want to setup for a few different types of lipos I have.
#612
When you go in to where you picked "edit" for the included profiles there is an "add" option, use it instead of edit to create your own and name them as you wish
You can also use the move function in this same place to arrange them in your preferred order once you have everything set up.
You can also use the move function in this same place to arrange them in your preferred order once you have everything set up.
#613
Tech Adept
Looking at setting up the unit to discharge through the load bank but when I set it up its pulling the battery down to 3.5V @ 30A Amps but then when its done it goes back up to 3.9V and the battery is not even warm. I'm thinking that I may have some setting wrong but not seeing it. I can still pull out 2000mah on the gfx charger after it is done on the ichager and the battery is warm.
#614
Looking at setting up the unit to discharge through the load bank but when I set it up its pulling the battery down to 3.5V @ 30A Amps but then when its done it goes back up to 3.9V and the battery is not even warm. I'm thinking that I may have some setting wrong but not seeing it. I can still pull out 2000mah on the gfx charger after it is done on the ichager and the battery is warm.
#615
You have to look at the end% I don't have my charger here but if you cut of at say 50% to say 5% also could be with balance detect options you have selected but it most definitely will drain a battery and make it hot if setup correctly did you increase the discharge amps?