balance board help
 

hey guys needs some help i brought one of these paraboard charging plates for lipo and im confused as to what deans plug matches what balance tab any help would be great

Doesn't matter, they are all in parallel with each other.

Deans does not make any plugs to fit the white balance ports. I looked up that board and it's difficult to understand what it's capable of or how it works due to the poor chinese translation.

The Paraboard has plugs for both Deans and balance taps. The Deans are in the middle. They are available with other main plug and balance connector types. It is for parallel charging multiple packs of equal cell count at the same time. I can post pictures with everything hooked up to make it clearer, later when I get to a real computer.

Here is a typical parallel board hookup. Both main wires and balance wires are connected both from packs and to the charger.

- Packs must be the same series cell count.
- Ideally packs should be reasonably close in voltage, perhaps within a couple tenths.
- Packs should be in reasonably good balance and condition.
- Capacity of packs can be different. Yes, they really can, even by a lot.

http://epbuddy.com/Slider/images/Par...ging_Setup.jpg

thanks Dave H