DX3C and Orange RX?
Will the orange RX work with the DX3c radio?
|
Yes, I only use OrangeRX receivers and they work fine with my DX3c. They also work with the new DX4s
|
the orange are DSM2, the DX3C is approved to run DSM1, DSM2, and Marine protocol receivers so you should be fine!
|
Is there any special way to bind these other than per the instructions? I bought one on ebay and I can't get it to bind with my DX3C. Thanks in advance.
|
Originally Posted by eddiemoney13
(Post 12255776)
Is there any special way to bind these other than per the instructions? I bought one on ebay and I can't get it to bind with my DX3C. Thanks in advance.
|
Originally Posted by edonsohc
(Post 12255877)
i've always had to unplug my servo to get mine to bind. i know a lot of "higher end" servos draw lots of power. it does usually take a couple tries though. i've never gotten a spektrum system to bind on the first try. even when using the name brand receivers.
I'll give it another go again tonight. Hopefully I can get this to work. If it's junk, it's a good thing it was only 11 bucks. |
Be careful with those orange rxjunk. I bought one to give it a test run. It lasted 2 weeks. Cost me the lead at out main event during a pit stop. It just popped and was toast.
Spend the extra few bucks for the real thing......Just my 1/2 cents worth. |
All times are GMT -7. It is currently 06:28 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.