Rx8 and servo help
 

I come from a rock crawling rc background and have taken my first venture into a Losi 8ight 2.0 e. I have installed a used Rx8, hitech 5955 servo, turnigy 1900 kv motor, and turnigy 6000 mah 2S 65-130C battery. I am using a Futaba 4PL tx/rx combo.

After I turn on the esc, I can get the car to go forward or reverse, but as soon as I steer the car goes hard lock right and stays while the esc flashes all lights. I am trying to figure out if my radio is programmed wrong, my servo is junk or is analog (I need to research that), if my esc needs programmed, or what I am doing wrong.

I did search for answers, but have not found anything satisfactory. Any help will be much appreciated.

Look up Randy Pike in the official Tekin RX8 post in the electric offroad section, He will help you figure it out