Robitronic Pro Master Motor Dyno: can anyone hel me?
03-14-2013, 04:56 AM
#1
Robitronic Pro Master Motor Dyno: can anyone hel me?
Hi,
I'm the owner af a Robitronic Pro Master dyno Plus version (made for motors under 10 turns).
I'm very happy with this Dyno (it's very well made, maybe the king of the flyweel dynos), but unfortunately the unit simulates the voltage drops of the NiMh batteries (about 0,04.Ohm).
Could anyone tell me what I have to do avoid this?
I would like to have the dyno without voltage drops, that doesn't simulate batteries, NiMh or LiPo.
Unfortunately, the max voltage on the motor under a test run is always under the set value.
I would like to know if there is some chance to change the NiMh simulation.
I have already written to Robitronic, but they replied this:
"... It is impossible to have no drop! Any supply will have voltage drop – you have voltage drop on wire – on connector and on battery internal ...".
They haven't understood that I was speaking about the voltage drop simulation made by the Dyno software...
I have sent another email but I haven't received reply.
Please, help me. Thanks in advance.
I'm the owner af a Robitronic Pro Master dyno Plus version (made for motors under 10 turns).
I'm very happy with this Dyno (it's very well made, maybe the king of the flyweel dynos), but unfortunately the unit simulates the voltage drops of the NiMh batteries (about 0,04.Ohm).
Could anyone tell me what I have to do avoid this?
I would like to have the dyno without voltage drops, that doesn't simulate batteries, NiMh or LiPo.
Unfortunately, the max voltage on the motor under a test run is always under the set value.
I would like to know if there is some chance to change the NiMh simulation.
I have already written to Robitronic, but they replied this:
"... It is impossible to have no drop! Any supply will have voltage drop – you have voltage drop on wire – on connector and on battery internal ...".
They haven't understood that I was speaking about the voltage drop simulation made by the Dyno software...
I have sent another email but I haven't received reply.
Please, help me. Thanks in advance.
Last edited by obsession4x4; 03-16-2013 at 04:38 AM.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
