Spectrum help please!!!!
 

Ok guys so I wanted to get a new radio instead of using my m12 for bashing and stuff like that so I picked up a new dx2s from amain. Tore it open read the directions and I have done everything like it says. I noticed something odd. When I put the bind plug in it didn't flash if I took it out then it would flash so I sent power through the throttle port and tried it that way. Still this same thing. Maybe I am missing something here but this thing will not bind to save my life. Now the led is solid but no servo response. Any help is greatly appreciated.
Thanks Dakota Burnette

You are putting the bind plug in, then sending power to the receiver right? If its already on and then you plug it in it won't go into bind mode.

Sure am is there any way I can reset it all?

Put bind plug into bind port on receiver, power up receiver (Receiver blinks rapidly), hit bind on transmitter and wait for receiver to finish binding (Can take 5-10 seconds to properly finish), turn off receiver and unplug bind plug....done.

That's it, that's all.