Using micro 4mm bullets
 

Hi,
My friend wants to know if you can use "micro" 4mm bullet connecters to connect an esc to a motor. His not sure if he will lose power by using these.He doesn't have a micro he is using a slash 1/10 scale sc and is about to solder his plugs on his new esc and motor

What's a "micro" 4mm bullet? Smaller than 4mm?

If it's really 4mm bullets it should be fine, just be sure they are well insulated so they can't short out with each other.

Here a link http://www.amainhobbies.com/product_...-Male-3-Female

I've had a lot better success with the solid prong kind, like the Tekin, Castle, and Proteks shown just below those.

Would I lose peformance using the plugs showen above?