Racing4Evo

iTrader: (2)

I had this happen and unfortunately nothing worked and I had to send it in to be reflashed.

Racing4Evo

iTrader: (2)

Yes. The bigger the capacitor rating the better but you will be fine and hard pressed to notice a big difference so long as you are running 2s Lipo.

MeBeMikey

Hey Luke, Three times I tried to do the update. The first time my computer was dead, next the updater failed to open properly and then 3rd time it wouldn't connect at all. I have used it several times to update firmware and never had a problem. I am going to stick with 5.4 as it seems the Universe is telling me to stick with it. I listen to the Universe and I am not happy with its decision.

See yah tomorrow. 5.0 vs 5.4

Mike

silden

iTrader: (12)

Hi,
What is the difference between the 4.7/5.4 and the 5.0 firmware?
Thank you

cplus

iTrader: (11)

Explained in the fact sheets when you download them.

Specific firmware for stock, mod, onroad/off etc.

rendangubi

iTrader: (1)

hello...
what is the best start ratio for flow worksteam + x12 13.5t firmware v5.4 track about 35-40 meter long...and i'm running boosted ....tq

silden

iTrader: (12)

I know that 5.4 is stock, 3.8 is off-road and 4.7 is mod.
But what is 5.0.

geeunit1014

iTrader: (14)

5.0 is the old stock software. 5.4 is the newer stock software

Dual Fuel

Hi guys, is there any way to know what firmware version is in the speedy as i got it second hand, but I dont have the bridge . thanks in advance

Racing4Evo

iTrader: (2)

No, I don't know if any way except for the bridge. You can maybe narrow it down to a few firmwares based on how many programming modes you have access to but it gets trickier after that.

Racing4Evo

iTrader: (2)

I'm hearing there will be a replacement for the LRP Flow released in Summer around July.

swerv512

iTrader: (21)

I was just about to pickup my third FWT ESC... maybe i'll wait now.

piorc

Hey guys, im using my LRP FLOW with Trinity D4 13.t in blinky.

Any advices on setup ?

silden

iTrader: (12)

I suggest to use the 4.7 "mod" firmware and set it to blinky-mode 5 and 6 to zero. The main difference between the 4.7 and 5.4 firmware are that the brake on the 4.7 feels stronger and the throttle on the 5.4 is a bit more aggressive. I only use the 5.4 for boosted stock and 1/12 mod classes.
I hope this helps.
Denis

Racing4Evo

iTrader: (2)

I think you can use 5.4 just change the brake mode from the default setting which is pretty bad IMO. I like the brakes on 4.7 better but 5.4 has much better throttle feel for stock.

I usually run5.4 firmware settings: 5,2,2,6,0,0,0