desolder esc tips
I have to desolder wires that came on a lrp sxx v2. The 12awg that it came with is too heavy for pan car so need a smaller gauge. The manual said to try not to hold heat to the esc for more than 5 sec at a time and i was wondering if there were any tips for easiest removal. I have a 40w iron with a big tip but didnt know if it was too hot. I have a smaller iron but not sure it will work well on all the factory solder on the esc
|
You want that 40W to transfer heat quickly. Get some solder wick or braid or a desolder tool (basically a syringe to suck up the excess solder).
|
I use something like alligator clip to "absorb" the heat before it reaches the ESC board
|
Worked, thanks for advice. Used a solder vacum and came off easy
|
All times are GMT -7. It is currently 08:45 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.