Originally Posted by Micah123

anyone?

Originally Posted by COBRARACING

Everything your doing is correct the reason why the lcd box wont wont when the rx cable is still in the receiver is the radio signal takes priority over the programmer so you either remove the rx cable from receiver or you disable radio signal .there must not be any radio signal input while programming with lcd programmer and thats because the 3 pin programming port is actually designed into thr receiver rx port as the mcu has only one pin that is used to program.

Originally Posted by R40Victim

I just got the 150 amp ESC and installed in my T8E(8th scale buggy) The Motor needs to turn the opposite way(clockwise in stead of counter clockwise) Can I do this without a program card? It is mentioned in the manual, but not how to change it. It's under "advanced items"

Originally Posted by nickdawg18

I'm switching to hobbywing this year after I fried a brand new Tekin gen 2. I was told that I should get the sct combo to run in my buggy. I assume it's this model http://www.falconsekido.com/products...sct-pro-series

Is that the go to setup that everyone is running in buggy? Does it have more setup options? What makes it better then this model? http://www.falconsekido.com/products...ox-for-1-8-car

Thanks guys.

Originally Posted by nickdawg18

I'm switching to hobbywing this year after I fried a brand new Tekin gen 2. I was told that I should get the sct combo to run in my buggy. I assume it's this model http://www.falconsekido.com/products...sct-pro-series

Is that the go to setup that everyone is running in buggy? Does it have more setup options? What makes it better then this model? http://www.falconsekido.com/products...ox-for-1-8-car

Thanks guys.

Originally Posted by R40Victim

I just got the 150 amp ESC and installed in my T8E(8th scale buggy) The Motor needs to turn the opposite way(clockwise in stead of counter clockwise) Can I do this without a program card? It is mentioned in the manual, but not how to change it. It's under "advanced items"

Originally Posted by rcboy1

That will work Nick, but you must get the Pro-D combo if youre running ebuggy. The rest of the combos have too short of a motor that is also too high kv. not 1/8th e friendly. I run the 150amp Xerun Combos (your second link, M6c or M6b).

Really the sct pro is just a smaller lighter esc thats more at home in smaller spaces. Really not much is different for adjust-ability. Other than that its a bit cheaper.

Originally Posted by nickdawg18

Cool. Thanks man. You gonna be at dirtburners this Saturday?

Originally Posted by FastPete

The LCD card makes life easier. But I just looked at the instructions, and don't think you have to have it. Just follow the instruction's, and see if it will let you get to that parameter.

Originally Posted by rcboy1

That will work Nick, but you must get the Pro-D combo if youre running ebuggy. The rest of the combos have too short of a motor that is also too high kv. not 1/8th e friendly. I run the 150amp Xerun Combos (your second link, M6c or M6b).

Really the sct pro is just a smaller lighter esc thats more at home in smaller spaces. Really not much is different for adjust-ability. Other than that its a bit cheaper.

Originally Posted by R40Victim

IT WORKED! lol Thank you so much, I just had to reread the manual a few times to "get it" Got a little weird with longer beeps representing 5, but I got it.