sickpuppy1

iTrader: (32)

I have found more than once,on different brands, not being able to communicate when the esc is plugged into the receiver. try that too. Make sure the vehicle is off the ground b4 applying power,just in case.... failsafe should keep motor from spinning but you never know....

savage24x

iTrader: (17)

Is the 2100Kv motor worth anything? Have one I got in a parts lot. Never heard of Viper.

Cain

iTrader: (292)

it works fine like other 1/8 motors.

nikos2002

iTrader: (30)

Viper was the original brand that became Maclan. All newer versions are done under Maclan Racing. That 2100 was a nice strong motor.... still running mine. On and off for about 4 years.

Elpuro

nwv327

anyone up for beating a dead horse? just got around to updating firmware and now my esc fan wont work?

Cain

iTrader: (292)

trying to remember but I think maybe it comes on at a certain temp maybe programmable too?

vondegroot

iTrader: (5)

Did you update a VTX10? Mine is cutting out after 5 minutes All the leds flash rapidly, but nothing is overheating!
Confused and wanna try a reset, but don't wanna waste $20 on a data link if I can't find firmware hehehe.

Aloha_

iTrader: (1)

This is nice to know (the viper to maclan), I never knew, I like the VTX10Rblack (the couple of times that I've used it) for the absolute beast that it is, and the 32 bit resolution?(if I'm not off there) smoothness and dial-ability of the Maclan mmax 160 pro. The only two I've considered keeping out of the various brands that will go off with cars I sell : )
Best post I've read in quite some time : )

kutless

iTrader: (2)

Does anybody know what the difference is between the VTX10 and the VTX10 Black Edition? I know the standard one is rated for up to 3s and the black edition is 2s only but they seem to be completely identical other than that.

deadmancourt

iTrader: (11)

Anybody have any experience having to change the external BEC? I have a couple of these vx10 esc and love them. But 1 is acting up and was told the BEC is no good.