R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)
-   -   Spektrum DX3R... HELP!? (https://www.rctech.net/forum/radio-electronics/450006-spektrum-dx3r-help.html)

TheChad003 11-05-2010 02:46 PM

Spektrum DX3R... HELP!?
 
i picked up a DX3R on here and i got it, and tried binding it with a SR3100 that came with it, and it goes into bind mode and flashes goes solid afterward supposely indicating a good bind, but the wheels turn on there own and the throttle goes on its own and i have no control over the car, idk what to do....... i have tried rebinding and nothing..... thanks in advance for any help

garry1970 11-05-2010 02:57 PM


Originally Posted by TheChad003 (Post 8170920)
i picked up a DX3R on here and i got it, and tried binding it with a SR3100 that came with it, and it goes into bind mode and flashes goes solid afterward supposely indicating a good bind, but the wheels turn on there own and the throttle goes on its own and i have no control over the car, idk what to do....... i have tried rebinding and nothing..... thanks in advance for any help

you should call the support line at spektrum, i'm sure they can tell you what's going on.:nod:

Dave H 11-05-2010 03:24 PM

Grasping a little here, but make sure the plugs are in the receiver correctly, I've seen and heard of that mistake several times. Black/negative to the outside. The light flashes quicker if backwards if i remember correctly.

locked 11-05-2010 03:37 PM

You probably need to re-calibrate the transmitter's parameters. I forget what the menu item is called right now. I'm at the office, so can't check mine, but there is a mode where you can reset the calibration. Once you find that area, you basically turn the wheel full left and then full right, let go. Pull the trigger full throttle, then full brake and let go and then save.

Don't do this with the receiver on.

You might need to re-bind after. You will need to calibrate the ESC after.

I think the menu might be called "parameters" or "reset parameters". Something like that. If no one else responds before tomorrow, I'll check my radio and let you know. I'm pretty sure this is what you need to do though.

Dave H 11-05-2010 04:03 PM

^ locked: Reset - Parameters - Yes - then move the controls as described - Save.

Worth a shot, shouldn’t hurt anything. But then reset everything as mentioned. But if it’s new to you gotta do that anyway as you set it up in a car.

(and hey, get back to work and quit goofing around :smile:)

TheChad003 11-05-2010 04:16 PM

I have recalibrated the parameters and reset the esc. But not both at the same time. When I get hone from work I'll try again. Is there a way reset the whole transmitter to factory default?

Ei8ht 11-05-2010 06:43 PM

What brand of esc is in your car?

TheChad003 11-05-2010 07:13 PM

So apparently when i was calibrating it I was doing it way wrong. And I think i got to work I think

TheChad003 11-05-2010 07:16 PM


Originally Posted by Ei8ht (Post 8171786)
What brand of esc is in your car?

The RTR Bruahless one


All times are GMT -7. It is currently 08:22 PM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.