HW Ezrun 60A HELP....
 

im currently using da Ezrun 60A + 5.5T combo set with a 2s 25-30c Lipo...
it has not been a week n im having a problem with my esc..

the prob is da when i turn on my esc, it only produce a red blink..usually it will be a few sec solid red...my servo n external fan was also not responding...i had open up my esc n didnt found any burn marks..so i re plug all my wire except to my receiver,n turn it on again..a solid red appears..bt as soon as i reconnect to my receiver,it happen again..
so i tot it cud be due to my receiver,so i took my old 1.74gHz receiver n give it a try...no luck...same thing happen again...

any recommend or opinion