Programming new ESC
 

I plan on upgrading on upgrading my ESC for a Novak Ballistic.
I have a Sanwa MX3-X and have programmed all the settings.

When I change the ESC, do I need to program it or do I just use the parameters I have setup on the transmitter?

If you're asking about the calibration of the radio to the esc - that will have to be done again. If its EPA and those kinds of adj that are stored in the radio, you shouldn't have to do that again. Wouldn't hurt to write them down just in case so you won't have to re-do them, just set them back to the same values.

Thanks a lot.:nod:

.