k_bojar

iTrader: (30)

gotcha Ed - I was wondering if that would have worked, but was having to do a completely new setup on my car at the track and didn't want to try. I think the original tekin software related brake force to reverse power - so if you reverse at a lower rate, you brakes were almost non-existent. kinda like the reverse setting (when not used), is like the speedo's brake range. set it at 25% (default, I believe), would only give you a 1/4 of the brake range

I'll give it a shot - I'm assuming once you do that, then the brake level is more effective??

ATLASCOPCO

Bump

Pro10noob

iTrader: (13)

From what i have heard and seen is only the holder that keeps the timing insert in it's place, changed from plastic to alloy.

Regards Roy

VA_Racer

iTrader: (21)

I have the new version of the program box and the 120a 1s version 2.1 . Do I have to have the esc wired to program the esc it wont connect to the program box at all. What am I doing wrong?

Pro10noob

iTrader: (13)

You have to use a 2s lipo to get the 1s esc to work and yes you need to connect the esc/reciever cord to the box.
Then turn on the esc and it connects to the box if all is ok.
Read the manual of both devices.

Regards Roy

VA_Racer

iTrader: (21)

it was kind of unclear the way I read it. do the motor wires need to be connected also?

Pro10noob

iTrader: (13)

I always do as i program it when it is in the car


Regards Roy

VA_Racer

iTrader: (21)

ok thanks for the help I figured it out. Now another ? is do I have to tell it i'm running a 1s batt or is it automatic and which version is blinky ? I see stock allows timing.

maRRRco

TryHard

iTrader: (4)

You'll need to load the '508_no timing' software onto the 120a 1s to have to running in an approved blinky mode.

HiH
Ed

hyujmn

iTrader: (27)

No matter what software you have on there, if you set boost/turbo to 0, the ESC will blink like in blinky mode.

MattW

I'm pretty sure that is only true for the V3/3.1. I'm fairly sure that Ed's advice is accurate for the V2.1.

hyujmn

iTrader: (27)

If I set up my v2.1 with mod software and set it to 0 timing, it blinks too. I used to run a 120a in blinky with the latest mod software.

jasons56

What is the status on Roar blinky approval for 3.1 1s version?

Thanks!

COBRARACING

The Hobbywing Xerun-120A V3.1 Stock Spec has met the electrical requirements for ROAR non-timing operation with software version V3.1_121129_Beta.