Spektrum recievers
 

Picked up a used DX3.0 now just need a couple of receivers for the TL MiniT and Vendetta TC.

Any issues with just the standard SR300, recommend any other low cost receivers that will work with the Spektrum DX3.0?

I've just got an SR300 for my slash, and using it with a DX3.0 it works great! :nod: Also ran it with my DX2.0 without any problems. A couple of guys at my local track also run SR300 receivers.

Im trying to bind a SR3500 with my SM1001 with out any luck ....any help out there?

Just a couple of questions.
First off, are you following spektrum's guide to binding correctly?

Secondly, are they both new? Or did the problem just recently pop up? If at all possible, try binding the receiver to another transmitter or try binding another receiver to this transmitter. It's possible that either the receiver or transmitter is faulty. If 1 of them is faulty, you'll have to contact spektrum and have it fixed.

Good luck!

they say to put binding plug into the b slot, then they say to turn on ur reciever ....well what slot u plug ur batt. into ? LOL

For binding, you can plug the batt into any slot. Just make sure you don't get the polarity wrong.
EDIT: I normally just plug it into the AUX slot.

Thanks...my SR3001 works great ....but now im trying to bind a new SR3500

I might have, so now tre reciever is shot?

Ouch! Its definitely possible that something got fried... I would've thought it would just damage the channel you plugged it into, but I may be wrong.
Your best bet would be to give spektrum's customer service a call.

hmm..
 

Isnt the SM1001 a DSM (v1) and the 3500 a DSM2?

thanks for that link,,,,from what it says ..no problem about hooking the batt. backwards time to try again ...im using a 3pk i might need to find a open mode

so i need a different module? that sucks lol

anyone have the number to spektrums costumer service? lol

No, the 3500 is just dsm (in other words version 1). There's a 3100 and 3520 that are dsm2. So that's not your problem. It must be something else.

Here you go: Customer service.

THANKS MUCH, Ill get this fingered out one way or a nother :lol: