Orca OE1 MK2
 

Hi does anybody tryied to replace the pwm cable? because i have a very stress time working on it.
I bought mine last month, and when i open the esc I saw the cables unprotected and very close to which other almost touching, so then i tryied to unsolder the boards, but couldn't do it so I manage to solder new wires but the space was realy very small. this litle job took me almost 3 hours.

Now I have a shorter new wire, and I m in love on the smothness of this ESC. Can't waint to try out on the track.

Any settings that you guys recomend to race 13.5 blinky?

I took some pictures but i can not upload them yet

havent found the need to replace mine yet, but if i do, I think you pretty much need to open up the ESC, desolder the cable from the board if the cable isnt under a glob of glue. If it is then pretty much cut off the cable and solder on a new one.

why would you open it and unsolder the wires when just cutting it and putting on a new plug is so much easier?