|
looking for advise
I have a traxxas slash 4X4 BL-2, Can i change my ESC to a 3s and run 3s batteries without hurting the motor?
|
Originally Posted by deanerD420
(Post 16076690)
I have a traxxas slash 4X4 BL-2, Can i change my ESC to a 3s and run 3s batteries without hurting the motor?
The BL-2s is not recommended to run on a 3s battery. |
Doesn't the BL-2S motor also have that strange proprietary plug? I suppose you could probably just cut it off and solder on some bullets, but just another thing to have to fiddle with.
|
Originally Posted by angrymelon
(Post 16076785)
Doesn't the BL-2S motor also have that strange proprietary plug? I suppose you could probably just cut it off and solder on some bullets, but just another thing to have to fiddle with.
You could, but I'm not sure if the leads are marked to indicate which point they are. |
Originally Posted by OffRoadJunkie
(Post 16076818)
You could, but I'm not sure if the leads are marked to indicate which point they are.
|
Originally Posted by angrymelon
(Post 16076827)
I don't think it matters for sensorless motors anyway. You would just have to swap the wires to make sure the motor is spinning in the correct direction.
This is true, but it would be nice so you don't need to desolder and resolder. Then again, if you're using bullet plugs, soldering wouldn't be an issue. |
| All times are GMT -7. It is currently 11:49 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.