![]() |
HobbyWing OTA Programmer (Bluetooth) Abnormal Communication
Picked up the newest HobbyWing OTA programmer the one that uses Bluetooth (P/N: 30850400). I was able to successfully use it with both an XR8 Pro and XR8 Plus a few times. Now when I plug it into the XR8 Pro it connects but when I try to load any parameters or even check the firmware I get the message "Abnormal Communication". Searching around I found one troubleshooting article on the HW support site (can't post the link) which wasn't helpful. I'm using the iOS HW Link V2 app version 2.1.4.
|
Originally Posted by bergstyle
(Post 16059192)
Picked up the newest HobbyWing OTA programmer the one that uses Bluetooth (P/N: 30850400). I was able to successfully use it with both an XR8 Pro and XR8 Plus a few times. Now when I plug it into the XR8 Pro it connects but when I try to load any parameters or even check the firmware I get the message "Abnormal Communication". Searching around I found one troubleshooting article on the HW support site (can't post the link) which wasn't helpful. I'm using the iOS HW Link V2 app version 2.1.4.
|
For some strange reason my HW OTA programmers (both the small square unit and Tunalyzer) will only connects when the transmitter is connected, otherwise I get the abnormal communication error.
|
| All times are GMT -7. It is currently 12:36 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.