XR10 PRO G2 CALIBRATION Help
#1
XR10 PRO G2 CALIBRATION Help
I have a Sanwa MT-44 that is working and I have steering.
All items are brand new
cable to motor fits kinda loose in esc. Not sure if this matters for calibration
When I calibrate I can do the following
Turn remote on and remote is on hold in FS.
1. Long press power -- beeps and blinks red
2. Leave Sanwa in center on throttle and press power blinks green once.
3. Pull back for Full throttle but when I push the button it turns red and cant get passed this step.
Then I have todisconnect the battery to turn off the esc
All items are brand new
cable to motor fits kinda loose in esc. Not sure if this matters for calibration
When I calibrate I can do the following
Turn remote on and remote is on hold in FS.
1. Long press power -- beeps and blinks red
2. Leave Sanwa in center on throttle and press power blinks green once.
3. Pull back for Full throttle but when I push the button it turns red and cant get passed this step.
Then I have todisconnect the battery to turn off the esc
Last edited by jaybirdy2k; 11-26-2020 at 06:12 AM.
#2
Had the esc in wrong receiver slot.....