Fs-gr3f
 

How do I unbind one of these receivers? I have 2 and they where previously tied to a different controller that broke. So I need to reset them to bind to the new controller. The light just blinks slow red and will not go into binding mode when the binding let plugged in. I see it has like a reset button but I can't figure out the sequence I guess.

Just bind the Tx/Rx as if the receiver was new. The button on the receiver is only used to set the failsafe setting.

What transmitter are you using?

Fs-gt3. I've tried that but the light just sets there flashing slow. It won't flash fast or just stay on. With it in binding mode or just set up as normal light just flash's slow like 1 flash ever 1-2 seconds. I know for a fact I'm doing the binding right I just can't figure out why it's just flashing slow and want do anything.

The controller and another reciver on my slash work just fine I run it every day.

Ok so I figured out the one on the slash flashes slow like that till the tx is turned on for it to connect to. So now why in the world won't it go into binding mode with the binding plug in and the power at the s+- plug? It still just flash's slow like it's waiting on a tx.

Are you pressing/holding the radio's bind button down as you turn the radio on?

Yep and it still just keeps blinking real slow like it looking. Idk what's going on.