Esc and new receiver and transmitter question / help
02-19-2019, 08:04 PM
#1
Esc and new receiver and transmitter question / help
I got a new transmitter and receiver ( futaba 3pv and r203gf) love them so far . My question is , once I install these will my esc settings that I had stay the same ? I assume so and that all I need to do is set all my epa and trims ? Correct ?? Thanks
02-19-2019, 09:20 PM
#2
There is a Radio & Electronics section of RCTech, this question belongs there.
You need to set end points, and recalibrate the esc. You might need to reverse the throttle channel, as Futaba radios usually need it reversed to work with an esc.
You need to set end points, and recalibrate the esc. You might need to reverse the throttle channel, as Futaba radios usually need it reversed to work with an esc.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
