R/C Tech Forums - Binding problems.

R/C Tech Forums (https://www.rctech.net/forum/)

- Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)

- - Binding problems. (https://www.rctech.net/forum/radio-electronics/1025359-binding-problems.html)

Binding problems.

Hello... this is my first post. I am trying to bind a RedCat RCR 2CE transmitter to a Fly Sky GR3E receiver. It will not bind! Any suggestions? Thanks Rob in Chicago

Quote:

Originally Posted by Robertalan51 (Post 15293701)

Hello... this is my first post. I am trying to bind a RedCat RCR 2CE transmitter to a Fly Sky GR3E receiver. It will not bind! Any suggestions? Thanks Rob in Chicago

i moved your thread to the proper area

Quote:

Originally Posted by Robertalan51 (Post 15293701)

Hello... this is my first post. I am trying to bind a RedCat RCR 2CE transmitter to a Fly Sky GR3E receiver. It will not bind! Any suggestions? Thanks Rob in Chicago

Here you go...

1. First - Make sure the vehicle and controller are powered OFF.
2. Insert the bind plug into the channel 4 "VCC" port on the R-3E receiver.
3. Turn on the power to the vehicle; this should give you a flashing red light on the receiver.
4. While holding the bind button on the controller, turn on the power to the radio.
- This should give you a flashing green light on the radio, and now the receiver light should blink slowly.
5. Power the radio and vehicle off.
6. Remove the bind plug from the receiver.
7. Turn everything on as normal - remote control first and vehicle second - you should be good to go.

Goodluck. Hopefully this helps.

As above to bind except the bind plug needs to be in CH 3 not CH 4 for the Flysky GR3E. The Redcat R3E is the same as the Flysky GR3F which uses CH 4 for the bind plug.

thanks guys ….I am a little confused by your suggestions but will try both methods. thanks again, Rob