MIP Eco drive Aluminum Transmission B5M SC5M T5M
06-16-2017, 12:22 AM
#1
MIP Eco drive Aluminum Transmission B5M SC5M T5M
Very hard to find these days. MIP ECO drive alum case and motor plate. works on B5m T5m SC5m. Everything you see included. Nothing more nothing less.
# Machined cases offer higher precision which optimizes gear mesh and efficiency when compared to molded plastic cases
# Aluminum construct acts as a giant heat sink which will cool the motor offering more consistent power due to reduced fade (less heat more power).
# Aluminum construct will offer stiffer bracing over plastic OEM case.
# Aluminum 3-gear MIP Transmission package is relatively the same overall weight as OEM 4-gear transmission. This will keep the weight distribution the same as what the car was designed to have. (MIP BOX 5.5 grams heavier)
# Motor offset 3mm to the right to optimize left to right weight distribution and balance (small spacer and new spring provided to accommodate this feature)
# Less drag than a four gear transmission design (one less idler gear).
# Can incorporate 5mm or 6 mm I.D. bearings
# 50% lighter gear cover over stock
# 7075 Aluminum
Additional info
MIP Eco All-In-1 Box Set, AE B5M, T5M, SC5M Trans #14300 *Discontinued*
You will need from your old transmission.
-Diff gear and bearings
-Idle gear, shaft and bearings
-Spur and slipper
-gear cover
I am looking for $sold firm shipped in the Cont. US
Low ballers will be ignored and NO TRADES as I am downsizing. I am in nooo hurry. Just getting rid of parts I no longer need.
# Machined cases offer higher precision which optimizes gear mesh and efficiency when compared to molded plastic cases
# Aluminum construct acts as a giant heat sink which will cool the motor offering more consistent power due to reduced fade (less heat more power).
# Aluminum construct will offer stiffer bracing over plastic OEM case.
# Aluminum 3-gear MIP Transmission package is relatively the same overall weight as OEM 4-gear transmission. This will keep the weight distribution the same as what the car was designed to have. (MIP BOX 5.5 grams heavier)
# Motor offset 3mm to the right to optimize left to right weight distribution and balance (small spacer and new spring provided to accommodate this feature)
# Less drag than a four gear transmission design (one less idler gear).
# Can incorporate 5mm or 6 mm I.D. bearings
# 50% lighter gear cover over stock
# 7075 Aluminum
Additional info
MIP Eco All-In-1 Box Set, AE B5M, T5M, SC5M Trans #14300 *Discontinued*
You will need from your old transmission.
-Diff gear and bearings
-Idle gear, shaft and bearings
-Spur and slipper
-gear cover
I am looking for $sold firm shipped in the Cont. US
Low ballers will be ignored and NO TRADES as I am downsizing. I am in nooo hurry. Just getting rid of parts I no longer need.
Last edited by czrlaker; 06-18-2017 at 03:07 PM.
06-16-2017, 12:23 AM
#2
Pic
06-16-2017, 12:53 PM
#3
Shaft in last pic is included
06-17-2017, 04:50 PM
#4
Bump
06-18-2017, 12:33 PM
#5
Bump
07-19-2017, 09:18 PM
#6
Tech Apprentice
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
