RC12R5.2 C&M conversion & Pro1 Conversion
02-01-2015, 10:18 AM
#1
RC12R5.2 C&M conversion & Pro1 Conversion
SOLD!!!!!!!12R5.2 with a C&M chassis conversion and a Pro1 rear axle conversion. This C&M chassis has only been run three times. It also has the stock chassis and axles as well as stock hubs. It will come with an extra new in the package set of Pro1 hubs. 19 pairs of new PRO1 tires, extra complete front end and two sets of spare lower arms, extra rear pivot block and axle and front ride height shims. Pro1 arbor that fits all pancar wheels and is needed for Pro1 tires. The tires are: 3 pair uncut green rears, 5 pair of blue fronts cut1.65", 4 pair of blue rears cut 1.65", 2 pair of XXblue fronts cut1.65", 2 pair of green rears cut 1.65", 2 pair of XXblue fronts cut 1.58", 2 pair blue fronts cut 1.58" and some old CRC tires that I had laying around. I will be removing the transponder and receiver. Futaba 9650, The Pace esc has a programming box and the instructions as well. I might have forgot a few items but the pictures are of what it comes with other than the receiver and transponder. I have it over on HobbyTalk as well. I will also include a Novak 17.5 motor and 13.5 stator.
I will sell the car as a roller with the C&M conversion, Stock axle, extra front end and the like new factory chassis, CRC used tires. Novak 17.5 motor and 13.5 stator.
$150 Shipped
$350.00 whole package
FREE SHIPPING CONUS
I will sell the car as a roller with the C&M conversion, Stock axle, extra front end and the like new factory chassis, CRC used tires. Novak 17.5 motor and 13.5 stator.
$150 Shipped
$350.00 whole package
FREE SHIPPING CONUS
Last edited by ThrottleKing; 11-01-2015 at 04:08 PM.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
