Motors SCTE 2.0 SC10 Berg 2.2 Clod HPI Pro 4
10-20-2013, 11:43 AM
#1
Motors SCTE 2.0 SC10 Berg 2.2 Clod HPI Pro 4
Some nice gear that needs a new home. Email pics on request.
3. Enroute Berg "v2" Roller w/motors, It does need a rear axle shaft that Amain has in stock for $10. I will explain because it sounds odd that a brand new Berg would need an axle... My wife threw it at me across the room and it must have landed on that one rear tire. Was just bent at first, but I decided to try and straiten it and snapped the wheel off. Black chassis/axles, weighted Berg wheels w/HB Sedona's,2x Integy 35t brushed motors, $old
6. Tekin redline 10.5 w/hi torq rotor and new bearings, works mint $sold
7. Thunder Power zx3 w/stock red rotor and green hi torq rotor, works mint $55
8. Vintage Clod Buster w/ESP alum chassis, Tekin Titan ESC, 2x sapphire 17t 18.5 awg brushed motors, 2x Hitec HS615 MG servos, This truck is dusty and one axle has a broken ear that the link mounts to but I have the NIP axle tubes for it. Needs work. SOLD shipped also have the Victor Engineering HI-IQ Super 10 charger in soft case to send w/it!
I only except paypal and shipping cost will obviously go up for buyers out of the 48 states. Please remember that roughly $30 on each roller will come right off the top for shipping and PP, I think the prices are reasonable but let me know.
I have more trucks/cars/parts/lipo's to list but this is a good start. Again I will email pics for serious buyers. Thanks, Chris
3. Enroute Berg "v2" Roller w/motors, It does need a rear axle shaft that Amain has in stock for $10. I will explain because it sounds odd that a brand new Berg would need an axle... My wife threw it at me across the room and it must have landed on that one rear tire. Was just bent at first, but I decided to try and straiten it and snapped the wheel off. Black chassis/axles, weighted Berg wheels w/HB Sedona's,2x Integy 35t brushed motors, $old
6. Tekin redline 10.5 w/hi torq rotor and new bearings, works mint $sold
7. Thunder Power zx3 w/stock red rotor and green hi torq rotor, works mint $55
8. Vintage Clod Buster w/ESP alum chassis, Tekin Titan ESC, 2x sapphire 17t 18.5 awg brushed motors, 2x Hitec HS615 MG servos, This truck is dusty and one axle has a broken ear that the link mounts to but I have the NIP axle tubes for it. Needs work. SOLD shipped also have the Victor Engineering HI-IQ Super 10 charger in soft case to send w/it!
I only except paypal and shipping cost will obviously go up for buyers out of the 48 states. Please remember that roughly $30 on each roller will come right off the top for shipping and PP, I think the prices are reasonable but let me know.
I have more trucks/cars/parts/lipo's to list but this is a good start. Again I will email pics for serious buyers. Thanks, Chris
Last edited by Blown up; 11-08-2013 at 10:44 AM.
10-20-2013, 11:47 AM
#2
