OFNA Hyper 10sc Brushless ARTR 4x4 SCT
05-19-2012, 03:00 PM
#1
OFNA Hyper 10sc Brushless ARTR 4x4 SCT
I have a like new OFNA 4x4 short course truck with upgrades and brushless system installed.
This truck has:
Aluminum Knuckles (the most common plastic part to break)
Other aluminum parts.
A Castle Creations 1406 4-pole brushless motor
A Hobbyking 100 amp car brushless esc (this this is awesome - bulletproof)
A hobbyking metal gear steering servo
You will need:
Transmitter and Receiver
2 cell or 3 cell lipo
Lipo charger
I am asking $325 shipped firm. I am not looking for trades. I would sell the roller separately (make offer by PM) but I am not selling the electronics without the truck. I don't really want to sell this truck, but I need money for my other projects. I'm not going to let it go super cheap.
The system will not let me link to my pictures because I am a newbee, but I have made 2 good trades here already. If anyone wants to link to the pictures for me in the replies, the link is <http>forringer.net/ted/craigslist/SC10-#.JPG where # is a number from 1 to 7.
This truck has:
Aluminum Knuckles (the most common plastic part to break)
Other aluminum parts.
A Castle Creations 1406 4-pole brushless motor
A Hobbyking 100 amp car brushless esc (this this is awesome - bulletproof)
A hobbyking metal gear steering servo
You will need:
Transmitter and Receiver
2 cell or 3 cell lipo
Lipo charger
I am asking $325 shipped firm. I am not looking for trades. I would sell the roller separately (make offer by PM) but I am not selling the electronics without the truck. I don't really want to sell this truck, but I need money for my other projects. I'm not going to let it go super cheap.
The system will not let me link to my pictures because I am a newbee, but I have made 2 good trades here already. If anyone wants to link to the pictures for me in the replies, the link is <http>forringer.net/ted/craigslist/SC10-#.JPG where # is a number from 1 to 7.
05-20-2012, 06:16 PM
#2
Bump.
05-22-2012, 04:03 PM
#3
Bump
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
