FS: FX10 - HPI F10 w/ Exotek
04-01-2012, 08:13 PM
#1
FS: FX10 - HPI F10 w/ Exotek
SOLD SOLD SOLD
Roller only, does not come with electronics. Has been run indoors on carpet less than a handful of times. I've made several mods to make it look more like an F1 / more tunable / faster. Raised rear spolier, modified body to look more realistic, added turnbuckles to allow front camber adjustment, hardware installed to put dampening tubes on the front suspension (just need the tubes).
Formula 10 ($120)
Exotek conversion ($80)
RIDE tires / rims around ($49)
Ball Diff Set ($43)
Dampening shock ($27)
Aluminum motor mount ($25)
Bearings throughout, extra bearings ($20)
Aluminum knuckles ($14)
Aluminum steering rack ($9)
HPI turnbuckles / ballcups ($10)
Set of HPI Rims / Hards (came with kit)
Over $400 and many hours put into it, hate to sell it but no one in my area runs these
Shipped to your front door for $225 paypal
Roller only, does not come with electronics. Has been run indoors on carpet less than a handful of times. I've made several mods to make it look more like an F1 / more tunable / faster. Raised rear spolier, modified body to look more realistic, added turnbuckles to allow front camber adjustment, hardware installed to put dampening tubes on the front suspension (just need the tubes).
Formula 10 ($120)
Exotek conversion ($80)
RIDE tires / rims around ($49)
Ball Diff Set ($43)
Dampening shock ($27)
Aluminum motor mount ($25)
Bearings throughout, extra bearings ($20)
Aluminum knuckles ($14)
Aluminum steering rack ($9)
HPI turnbuckles / ballcups ($10)
Set of HPI Rims / Hards (came with kit)
Over $400 and many hours put into it, hate to sell it but no one in my area runs these
Shipped to your front door for $225 paypal
Last edited by bdbachus; 10-03-2012 at 02:08 PM.
04-03-2012, 06:50 PM
#2
Bump
04-04-2012, 08:44 PM
#3
Bump
04-05-2012, 11:09 PM
#4
Bump
04-07-2012, 07:50 PM
#5
Bump, pms replied
04-08-2012, 12:02 PM
#6
Bump
04-09-2012, 03:31 PM
#7
Bump
04-10-2012, 07:34 PM
#8
Bump
04-12-2012, 07:41 AM
#9
Bump
04-13-2012, 03:15 PM
#12
04-13-2012, 03:21 PM
#13
Yes, I'm anticipating shipping to be around $25, so you're getting this car for $200, half of what I paid for it. Not including all the time I put into working on it, I am a "type A" btw, so these mods are legit and perfect. If i cannot sell it for $200, which is less than what you would pay for just the kit and exotek conversion, then I will leave it on my shelf.
04-13-2012, 03:31 PM
#14
HPIA301 or HPA302 - heavy duty ball cups
I could not find what I had for the turnbuckles, I could only find purple ones, but all you need is 34-40mm.
04-16-2012, 07:11 AM
#15
Bump
