MBX6 / Ninja / Futaba
11-21-2011, 06:39 PM
#1
MBX6 / Ninja / Futaba
Used Mugen MXB6 M-spec complete with Fubata servo's BLS351 & BLS451 and ProTek 5-Cell receiver pack. Mugen pro starter box with Max Amps 4S 6000mAh. MR Ninja and JX Ninja engines still run, Would probably put a front bearing and resize the sleeve to freshen up and get a couple more gallons out of them. Used Mugen Pipe and header. Everything works add receiver and fuel, set epa's and your ready.
Everything is in really good shape drive pin's, outdrives etc
Spares:
Mugen Hard Shoes
Mugen 1.0 springs
Fubata BLS351 "Lead was cut off"
Any questions PM me
$380 shipped Free ground in the lower 48
Everything is in really good shape drive pin's, outdrives etc
Spares:
Mugen Hard Shoes
Mugen 1.0 springs
Fubata BLS351 "Lead was cut off"
Any questions PM me
$380 shipped Free ground in the lower 48
11-21-2011, 10:32 PM
#2
Used Mugen MXB6 M-spec complete with Fubata servo's BLS351 & BLS451 and ProTek 5-Cell receiver pack. Mugen pro starter box with Max Amps 4S 6000mAh. MR Ninja and JX Ninja engines still run, Would probably put a front bearing and resize the sleeve to freshen up and get a couple more gallons out of them. Used Mugen Pipe and header. Everything works add receiver and fuel, set epa's and your ready.
Everything is in really good shape drive pin's, outdrives etc
Spares:
Mugen Hard Shoes
Mugen 1.0 springs
Fubata BLS351 "Lead was cut off"
Any questions PM me
$380 shipped Free ground in the lower 48
Everything is in really good shape drive pin's, outdrives etc
Spares:
Mugen Hard Shoes
Mugen 1.0 springs
Fubata BLS351 "Lead was cut off"
Any questions PM me
$380 shipped Free ground in the lower 48
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
