ArgonXenon2

iTrader: (3)

selling a brushless E-Maxx with a losi 8th scale xceleron programable esc(traxxas connector with series connector) a nue castle 2200kv motor, 1 JRsport st126mg high torque steering servo. has the old E-Maxx chassie, RPM upper and lower A-arms all around, RPM front and rear shock tower and body mounts, RPM tire nuckles all around, RPM skid plates frond, center, and rear, has 40 wt oil in the shocks, greace filled diffs, traxxax 17mm hubs, traxxas tallon tirs, 3 extra steering barrings, 2 spurrs, has the robinson racing spurr gear setup, and an all black custom reevo body. i am looking to get $350 for it or a trade for the new savage X 4.6 i can post pics if wanted/needed

ArgonXenon2

iTrader: (3)

tittelba

iTrader: (57)

I've seen this E-maxx. Doesn't it also include the steel constant velocity driveshafts from Traxxas for all four axles and the front and rear center drive shaft as well? These cost $120 alone and are bullet proof.

yzinger02

iTrader: (13)

Theyre not exactly bulletproof, a friend of mine bent one in a few runs with his xerun 2000kv system. And those cvds are more like $80, but there are cheaper ones for $50.

tittelba

iTrader: (57)

Incorrect, they're $80 for the set of 4 axles and about $40 for the two center shafts.

A crappy driver can break/bend any part no matter how well made they are. Maybe they were defective.

ArgonXenon2

iTrader: (3)

this car is gone i have already gotten rid of it

evojuggalo

iTrader: (40)

I had those axles also and bent the center and rear ones, of course I was using 6s