Brand new Scalpel RTR less transmitter
#1
Brand new Scalpel RTR less transmitter
I've got a brand new assembled Scalpel chassis that has has had the electronics mounted on it, etc, but never fired up. I've purchased all the electronics (back when I was going to run this thing...) and would include them. All the items listed below were purchased new for this build. The batteries (2 packs) I bought from a friend who never actually used them. All that needs to be done to run the car is finish soldering connections to the battery and run wires to whichever motor you want to use, install the receiver and go.
Base Scalpel kit ($130 from Stormer)
Hitec 85BB+ micro servo ($30 from Stormer)
Novak Micro GT esc ($80 from Stormer)
GWS Pico 75mhz receiver ($27 w/crystal from Robotics supply--the way to go for little cars like these)
Peak Performance Raider motor ball-bearing, etc ($40 from Tower)
All of the above was purchased new for this build. Fire up your 75mhz transmitter (or install your Spektrum system) and you're off to the races!
I'm over $300 into this thing plus shipping, would sell for $185/shipped in the US. If you receive this package and are disappointed for any reason I would buy it back (less shipping cost) provided it is returned in the same condition it was shipped in (ie not run). If interested my PayPal is [email protected]
Base Scalpel kit ($130 from Stormer)
Hitec 85BB+ micro servo ($30 from Stormer)
Novak Micro GT esc ($80 from Stormer)
GWS Pico 75mhz receiver ($27 w/crystal from Robotics supply--the way to go for little cars like these)
Peak Performance Raider motor ball-bearing, etc ($40 from Tower)
All of the above was purchased new for this build. Fire up your 75mhz transmitter (or install your Spektrum system) and you're off to the races!
I'm over $300 into this thing plus shipping, would sell for $185/shipped in the US. If you receive this package and are disappointed for any reason I would buy it back (less shipping cost) provided it is returned in the same condition it was shipped in (ie not run). If interested my PayPal is [email protected]
#2
I would also consider some trades, these items ONLY:
CKRW "Slash Killer" conversion (kit or complete)
Novak 550-series Ballistic motor
High-end digital servos appropriate for Short Course truck work (not particular about brand, but must be over 150oz-in and under .2 sec at 6v). I need TWO servos, can certainly make just one work.
Blitz ESE roller
Integy "Universal" set-up station and/or adapter sets for same
48p pinions 26t +
Mod-1.0 pinions 10t +
If it's not listed above, please save us both some time...
CKRW "Slash Killer" conversion (kit or complete)
Novak 550-series Ballistic motor
High-end digital servos appropriate for Short Course truck work (not particular about brand, but must be over 150oz-in and under .2 sec at 6v). I need TWO servos, can certainly make just one work.
Blitz ESE roller
Integy "Universal" set-up station and/or adapter sets for same
48p pinions 26t +
Mod-1.0 pinions 10t +
If it's not listed above, please save us both some time...
Last edited by Scottrik; 04-10-2011 at 08:30 AM.