Berg RC Rock Crawler Comp Crawler Ready to Run
11-29-2010, 07:53 PM
#1
SOLD Berg RC Rock Crawler Comp Crawler Ready to Run SOLD
SOLD
Up for grabs is my Berg Comp Crawler! Complete ready to crawl. Bind and drive!
This rig is dialed in and works great!!!
Details:
Berg Axles
Holmes Hobbies 35T Torque Master Motors
HiTec HS-5955TG Servo
Vanquish Hi Steer Knuckles
Traxxas Big Bore Shocks
Maham Wicked J wheels with extra set of brand new Rings
CDW Behind the axle steering
Fubar Crawler rear lockouts
Front axel clocked 20*
Custom Fubar Crawler Aluminum Chassis
CDW High clearance links (aluminum front, delrin rear)
FXR speed control
Punk Dig switch
Castle BEC
Spektrum SR3000 Receiver
3 X 1500mAh Lipo Batteries
Axial Body and chevy proline body
Hot Bodies Rover Tires
I have over $1600 into this rig
Selling everything for only SOLD shipped to lower 48
Thanks For looking
Up for grabs is my Berg Comp Crawler! Complete ready to crawl. Bind and drive!
This rig is dialed in and works great!!!
Details:
Berg Axles
Holmes Hobbies 35T Torque Master Motors
HiTec HS-5955TG Servo
Vanquish Hi Steer Knuckles
Traxxas Big Bore Shocks
Maham Wicked J wheels with extra set of brand new Rings
CDW Behind the axle steering
Fubar Crawler rear lockouts
Front axel clocked 20*
Custom Fubar Crawler Aluminum Chassis
CDW High clearance links (aluminum front, delrin rear)
FXR speed control
Punk Dig switch
Castle BEC
Spektrum SR3000 Receiver
3 X 1500mAh Lipo Batteries
Axial Body and chevy proline body
Hot Bodies Rover Tires
I have over $1600 into this rig
Selling everything for only SOLD shipped to lower 48
Thanks For looking
Last edited by 51504rock; 01-12-2011 at 08:28 PM. Reason: SOLD
12-02-2010, 10:38 AM
#2
X-Mas almost here!
12-07-2010, 05:19 PM
#3
Bump 
12-16-2010, 04:27 PM
#4
TTT
12-19-2010, 09:58 AM
#6
The inner axles are Berg and the outer stubs are axial. The 3rd gear has not been changes. I just did a compete rebuild of the axles with all new bearings and grease and all the gears are in excellent condition.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
