4wd Slash PE w/ Tekno's RTR or Roller
10-31-2010, 10:09 AM
#1
4wd Slash PE w/ Tekno's RTR or Roller
This is a fully built PE Slash, Tekno CVD's all around, RPM all around and bumper's, Lower Tray and body from Pro-line. Integy 1/8 adapters and wheel's already modded for Tekno CVD's. I have the 12 m hex's also. Kingheadz motor mount w/ large bearing. Titanuim pin's all around, Traxxass center diff and clear cover's. STRC Rear shock mount and Kyosho buggy rear shock's, larger rear SportWerks shocks are up front on the STRC mount. Castle MM and 2200 Monster motor 25/54 gearing. It can be ran a a 2s ( I run on 4s) for racing or 4s. It is very fast and handles good for a SLash.
For the roller 225.00 shipped
w/ ESC and motor 325.00 shipped. I will only sell ESC and motor seperate if the roller sells first. Then the ESC and motor will be priced at 150.00 shipped
Obligitory pics, ...
I will try to get one w/ the 1/8 set-up on it, otherwise you can see the STRC mount and Shock's/motor and ESC.
Thanks for looking, but I will look better at your house.
For the roller 225.00 shipped
w/ ESC and motor 325.00 shipped. I will only sell ESC and motor seperate if the roller sells first. Then the ESC and motor will be priced at 150.00 shipped
Obligitory pics, ...
I will try to get one w/ the 1/8 set-up on it, otherwise you can see the STRC mount and Shock's/motor and ESC.
Thanks for looking, but I will look better at your house.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
