FS: Collari/Werks 3 Port .21 Engine/Novarossi 63 Pipe
#1
FS: Collari/Werks 3 Port .21 Engine/Novarossi 63 Pipe
I could be wrong and this may be a 5 port - but i'm 95% sure it's 3 port. It has been sitting in the closet for a few years since I did my brushless conversion. I believe it had about 2 gallons through it since new.
It feels like it needs a sleeve pinch or new sleeve/piston but that may just be because it doesn't have a glowplug in it (don't have one around anymore to give a better answer). I have been told this is the same engine as the Werks Racing line.
The engine comes with a spare carb, set of air filters, and the novarossi 9863 pipe as seen in the pics below. Also comes with the clutch assembly and 13tooth bell (all Losi stuff). As you can see from the pics, it was not run hard :-) Practically no scratches on it at all.
Looking for $120 shipped for everything.
I have a Losi 8ight 1.0 chassis/gas tank/and radio tray I can throw in also if anyone wants those.
It feels like it needs a sleeve pinch or new sleeve/piston but that may just be because it doesn't have a glowplug in it (don't have one around anymore to give a better answer). I have been told this is the same engine as the Werks Racing line.
The engine comes with a spare carb, set of air filters, and the novarossi 9863 pipe as seen in the pics below. Also comes with the clutch assembly and 13tooth bell (all Losi stuff). As you can see from the pics, it was not run hard :-) Practically no scratches on it at all.
Looking for $120 shipped for everything.
I have a Losi 8ight 1.0 chassis/gas tank/and radio tray I can throw in also if anyone wants those.
Last edited by UberGamer; 07-03-2010 at 02:21 PM.
#2
TTT!
#3
Another bump
#4
Bump!!!
#5
bump again!
#6
bump bump bump
#7
Bump!!!
#8
Bump!
#9
bumpity!
#10
bump