Total Sell Out Mugen MBX5-T ProSpec+Parts+Futaba 3PKS 2.4
04-22-2010, 07:47 PM
#35
bump up.....its been a crazy week. im going to storage tomorrow to find that box for you
04-23-2010, 12:40 AM
#36
That would be great! It will fly Sunday.
So far I have pulled the engine and cleaned it up, pulled the Monokote off the firewall, straightened out the motor mount holes on the right side, fuel proofed the firewall with epoxy, tightened the Monokote on the rest of the plane with my wife's iron(while she wasn't looking), reworked the throttle linkage, cycled the tx and rx batteries 10 times each, and I'm reassembling everything now. Still have to check the radio but I'm close.
BTW the starter battery is toast
. I have one on the way.
Let me get it trimmed out and you can come fly it!
So far I have pulled the engine and cleaned it up, pulled the Monokote off the firewall, straightened out the motor mount holes on the right side, fuel proofed the firewall with epoxy, tightened the Monokote on the rest of the plane with my wife's iron(while she wasn't looking), reworked the throttle linkage, cycled the tx and rx batteries 10 times each, and I'm reassembling everything now. Still have to check the radio but I'm close.
BTW the starter battery is toast
. I have one on the way.Let me get it trimmed out and you can come fly it!
04-23-2010, 06:06 PM
#37
found the tool box i was looking for. there was an iron in it. if i remember right i bought that iron and only used it on tht plane. originl plns for the plane were also in it. let me know when you will be near austin again and ill meet up with you.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
