Mamba Max ESC + UBEC
06-08-2009, 09:57 AM
#1
Mamba Max ESC + UBEC
Hey all,
I've got a Mamba Max ESC for sale, works great, newest firmware is on it and a Castle Link cable is included.
It was used for a while in an RC10T3 with a Feigao motor. Never thermaled or hurt. It does have the BEC lead removed from the plug, as I used the included UBEC for it (6 volt for the servo). The UBEC is sealed in glue filled heat shrink and works great.
The only thing wrong with the entire setup is the sticker on the bottom of the Mamba came off with my servo tape, so it's just the black plastic casing.
The Mamba has a deans ultra (male) and bullet connectors on the motor leads (5.5 mm I believe).
$50.00 for the pair + shipping (shouldn't be more than 5-6 bucks in the lower 48).
Paypal only please.
I can put a picture up later today if it's wanted/needed.
I've got a Mamba Max ESC for sale, works great, newest firmware is on it and a Castle Link cable is included.
It was used for a while in an RC10T3 with a Feigao motor. Never thermaled or hurt. It does have the BEC lead removed from the plug, as I used the included UBEC for it (6 volt for the servo). The UBEC is sealed in glue filled heat shrink and works great.
The only thing wrong with the entire setup is the sticker on the bottom of the Mamba came off with my servo tape, so it's just the black plastic casing.
The Mamba has a deans ultra (male) and bullet connectors on the motor leads (5.5 mm I believe).
$50.00 for the pair + shipping (shouldn't be more than 5-6 bucks in the lower 48).
Paypal only please.
I can put a picture up later today if it's wanted/needed.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
