3-Shoe Clutch Shims...
#16
THD Shims available at A Main Hobbies now...
THD Part #080204A-01 & #080204A-02
There will be a Teflon shim available for the M2C 4-shoe clutch flywheel very soon also. I'll hopefully have some production done later this week.
Thanks,
Derrick Hochgesang
Team Hoagie Designs (THD)
Custom R/C Products
[email protected]
THD Part #080204A-01 & #080204A-02
There will be a Teflon shim available for the M2C 4-shoe clutch flywheel very soon also. I'll hopefully have some production done later this week.
Thanks,
Derrick Hochgesang
Team Hoagie Designs (THD)
Custom R/C Products
[email protected]
#17
If you are wanting to use the THD Teflon shim on your flywheel, but don't know if it will fit, take the measurements shown in the picture below using a caliper. If you're flywheel layout is within a couple thousands of an inch (+/- .002") then the shim should fit. Keep in mind that a used flywheel will more than likely have a smaller diameter pin, but the shim will still work as long as the pin spacing is the same. If your flywheel layout matches one of the layouts in the picture, and it's not an RC8 3-shoe or M2C 4-shoe flywheel, please contact me and tell me so. I would like to list all of the flywheels that these shims will fit to better inform others.
Thanks,
Derrick
[email protected]
Thanks,
Derrick
[email protected]