new HPI 4.1 engine with bumpstart backplate for 1/8 buggy

Reply Subscribe

Thread Tools

Search this Thread

12-26-2006, 09:56 PM

vintagetamiya

Tech Fanatic

Thread Starter

iTrader: (18)

Join Date: Sep 2006

Location: Dallas Tx.

Posts: 917

Trader Rating: 18 (95%+)

new HPI 4.1 engine with bumpstart backplate for 1/8 buggy

this engine has never seen fuel and has a backplate installed for bump start , i installed it in my XRAY buggy but was never started and the buggy was sold as a roller so this engine has to go ,will fit 1/8 buggies such as xray,mugen,ofna,kyosho,sportwerks,cen,losi 8ight etc.. anywhere a standard .21 to .28 engine fits.. tower has this engine at $149.99 ,reduced price $75.00 shipped to the lower 48.. this engine will need to broken in , break-in plug is included also..

Attached Thumbnails

new HPI 4.1 engine with bumpstart backplate for 1/8 buggy-engines-001.jpg

new HPI 4.1 engine with bumpstart backplate for 1/8 buggy-engines-002.jpg

new HPI 4.1 engine with bumpstart backplate for 1/8 buggy-engines-003.jpg

Last edited by vintagetamiya; 12-27-2006 at 10:54 AM.

12-27-2006, 07:23 AM

vintagetamiya

Tech Fanatic

Thread Starter

iTrader: (18)

Join Date: Sep 2006

Location: Dallas Tx.

Posts: 917

Trader Rating: 18 (95%+)

make offers.

12-27-2006, 10:53 AM

vintagetamiya

Tech Fanatic

Thread Starter

iTrader: (18)

Join Date: Sep 2006

Location: Dallas Tx.

Posts: 917

Trader Rating: 18 (95%+)

$75.00 shipped .......needs to go..

12-27-2006, 03:48 PM

vintagetamiya

Tech Fanatic

Thread Starter

iTrader: (18)

Join Date: Sep 2006

Location: Dallas Tx.

Posts: 917

Trader Rating: 18 (95%+)

going to flebay tonight.. make offers, i hate ebay

12-27-2006, 04:14 PM

Hugh

Tech Fanatic

iTrader: (14)

Join Date: Jun 2005

Location: Charleston,SC

Posts: 970

Trader Rating: 14 (100%+)

Hold off on ebay for a few hours. I'm gonna see if I can get this sold for you.
Great price!!

12-27-2006, 04:19 PM

Hugh

Tech Fanatic

iTrader: (14)

Join Date: Jun 2005

Location: Charleston,SC

Posts: 970

Trader Rating: 14 (100%+)

One more thing. Did you do any grinding to the crankshaft pin to put the backplate on? I want to see if it's pullstart/rotostart compatible,not that it's all that important. LMK.