R/C Tech Forums - Xray XT8 17/18 with Nitro and Etruck parts

Emaculate Xray XT8E Truggy with upgrades/options included (Parts for both Nitro and Etruck!!)

$600 + Shipping (less than the price of just the upgrades and the conversion kit)

Currently Mounted (Etruck setup):

Aluminum front end
Aluminum rear carriers
Graphite Diff Cups
High heat diff pins
XT8 Body brace (in the front)
XB8'18 wing mount
Emulsion shock caps with the '18 soft bladders installed.
Upgraded most of the cap head screws to socket heads where necessary.
Chassis has normal wear, no major damage.
Truck was rebuilt from the ground up after every race.
Outdrives are like new.
All pins replaced after showing minor wear.
Hobbywing XR8 Plus amd 2250kv motor.
M3 Electroshots

For the Nitro setup:

2 Piece motor mount (base only, you will need to get the upper parts to fit your engine)
Brake pads are in pristine shape as they do not have much runtime. They are upgraded to the pre-glued HD version.
Stock brake disks included.
Protek electronic Switch
AE springs on the the linkages (as seen in the pictures - Servo horn not included with sale).

As you can see, I also have the throttle linkage drilled out to work with an aluminum horn (Servo horn not included with sale).

Spares include (mostly NIP):

Body spacers
Full set of front and rear arms
Inner hinge pins
Full set of shock shafts
Rear outer hinge pins
Center drive shaft boots
New set of rear springs (should be replaced soon).
Black losi fuel tank pull (plus the one actually on the tank)
Stock rear carriers.
New Filter assembly.
8-hole MIP Bypass Piston kit.
Nitro cut body that is a season old.
Brand new Samuelson Designs painted body that only has mounting holes cut and custom decals from S1.
Extra rear diff and pinion (worn together)
Stock plastic C-hub front end.
I will dig up all of the spare bushings and pistons if you want them.
Bearings are new and have only a shakedown run on them. After that I cleaned the whole truck up.
Stock engine mounts
Will include a set of the 19 shock caps and bladders if you want them.

What you need to finish this truck up should be obvious so not really gonna list them.
You will need some air filters and a wire to brace the pipe if you run this nitro.
I also recommend a set of lighter roll bars for when/if you run this as an Etruggy.

Pictures can be found here:
https://1drv.ms/f/s!Ai7ZSjAOSZKxhOo8rLX3XlYBvATWVA
PM me with any questions. Not in a hurry to sell! Will accept offers, but low ballers will be promptly ignored.

Verified Paypal via Goods and Services only.