faskolor PSI
What PSI do you spray faskolor at? I have a Iwata HP-CR Revolution Airbrush, and spray at 50psi. On Parma's website they say 40-70 with a medium tip. What is considered medium?
|
Originally Posted by revo61
(Post 6513901)
What PSI do you spray faskolor at? I have a Iwata HP-CR Revolution Airbrush, and spray at 50psi. On Parma's website they say 40-70 with a medium tip. What is considered medium?
|
It comes with a .50 needle, but I can get a smaller .35 for it.
|
I believe Charlie was saying you only have one needle and nozzle combo out of the box. As you stated this is the .5mm set. With that in mind try using 60 psi to start out with. If everything sprays fine lower the pressure until it wont spray then come back up until it works again.
|
Originally Posted by NeoNot
(Post 6516983)
I believe Charlie was saying you only have one needle and nozzle combo out of the box. As you stated this is the .5mm set. With that in mind try using 60 psi to start out with. If everything sprays fine lower the pressure until it wont spray then come back up until it works again.
Always try on another material until you're comfortable with results. |
All times are GMT -7. It is currently 12:28 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.