Siphon or Gravity feed
#2
Tech Fanatic
iTrader: (1)
Originally Posted by DA_cookie_monst
Was looking at a new airbrush, one for all occaisions (I know, asking a LOT here) but was wondering what is the best for using with Faskolor, siphon or gravity?
oh, and why??
Thanks
oh, and why??
Thanks
This has been covered in numerous threads and answered by numerous people other than myself. Refer to: http://www.rctech.net/forum/showthre...37#post2016937
Cheerio!
Cassidy
#4
Tech Fanatic
iTrader: (1)
Originally Posted by DA_cookie_monst
Thats great, sorry for my laziness.
How do yo uthen fluch clean the gravity feed brush after use?
How do yo uthen fluch clean the gravity feed brush after use?
If it's a warm warm or cool cool (green to blue, orange to yellow) I might spray a little water or just burn through some extra paint. This also makes for good fades, obviously.
#5
Tech Elite
iTrader: (17)
I just get a cup of hot water , fill it with some windex and alcohol....submerge the tip and inlet of the airbrush and spray away. I then take it out.
Put my finger of the top and spray , this jets the air back into my brush and squeezes it out of the paint inlet.
After doing this process a few times and making sure nothing spits back out. I then fill up a little fasklean and spray that through the brush from low to high pressure.
Then spray until its dry and I let it sit...sometimes taking it apart after im done for the day and cleaning it thoroughly.
Put my finger of the top and spray , this jets the air back into my brush and squeezes it out of the paint inlet.
After doing this process a few times and making sure nothing spits back out. I then fill up a little fasklean and spray that through the brush from low to high pressure.
Then spray until its dry and I let it sit...sometimes taking it apart after im done for the day and cleaning it thoroughly.