Tool for removing/install piston circlip?
 

Just wondering what everyone uses for installing and removing the piston circlip on gudgeon pin on a .12 nitro engine.

Have found fine tip needle nose pliers too large (hardware store bought) and bought some exceed right angle tweezers but bent to the tip.

Thanks in advance!
BB

I also use the exceed tweezers or my finger nail .Sometimes I also hold it in place with my thumb and push the other end in with my index finger nail.Helps from loosing the circlip for sure.Then I make sure its seated with the tweezers or a 1.5mm hex tool.

Piston clips
 

This is a task best performed with your hands and the piston in a clear plastic bag.

I use my fingers and the backside of an exact-o knife.

Pass you soon...

Exacto to remove it, fingers and exacto to install it. I always order double the clips I need:D:lol::nod:

+1

Go to local beading shop or ebay and buy Bent Chain Nose Pliers one brand name is beadsmith like the ones from the hardware but very small.

I use surgical forceps similar to these

http://www.ebay.co.uk/itm/Mosquito-F...cAAOSwGotWrLN7