1/8 refueling
 

Hi guys,

me and my mates have a hard time to refuel our MRX5´s with the fuel gun. It is difficult to open the tank lid when we wear gloves and the roll bar is very close to the cooling head of the engine which resulted in some bleeding knuckles already.

So are there other roll bars available which fit the MRX-5? Have seen one which is angled on Robert Pietsch`s car...

And which mods could be done to the lid? Have seen something like a tab there...

Thank you yery much in advance! Cheers, Stefan

Moderator Please move to "onroad" section. Was still a bit sleepy whilst typing this. Thanks!

use zip tie

bump


anyone?

Then bent roll bar can be accomplished with a vise and the stock bar. Its not hard to fab your own. Locall steel suplier a couple of cock-tails and wala you have made your own.
Empire racing made a really nice handle for the tank. There again you can make your own. I'm making some rite now out of carbon. Aluminum could be easily formed into what you want. Just be sure you make a nice backing plate so you don't snap the handle off of the tank.