SG pilot style shaft engine in RS4 3?
10-19-2004, 05:06 PM
#1
SG pilot style shaft engine in RS4 3?
Anyone know if a pilot shaft engine can be adapted for the RS4 3. I'm thinking NTC3 non-pull flywheel, clutch nut and HPI clutch and bell.
Thanks,
Dan
Thanks,
Dan
10-20-2004, 11:03 AM
#2
10-20-2004, 06:39 PM
#3
Thanks a lot!
Do you know if the RS4 clutch bell and bearings will work with the SG shaft?
Do you know if the RS4 clutch bell and bearings will work with the SG shaft?
10-24-2004, 01:55 AM
#4
Hm, the instructions arn't clear. It says that a clutch nut is required and hub shims are recomended. You might try and contact Wofgang about what exactly would be needed.
10-24-2004, 03:40 PM
#5
Thanks, I'll do that.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
